To find your Static Water Level In Your Well Pipe,
Here is what
you'll need.
A
large
fishing bobber.
They are normally red on bottom & white on
top. (Wal Mart, fishing dept),
you'll need a
large washer,
next get some twine/string,
(not too thick) say 100
ft. Now you are going fishing...so to
speak. :-)
Tie the washer to the
end of the twine/string.
Next tie the bobber about 6 inches to a
foot above the weight. Now
lower that down
your well opening...the bobber will float
when it hits water and go slack...you should
feel it get lighter...(Make
Sure It Is Hitting Water...bob it up and
down rather quickly , you should hear a
blooping sound as the fishing float hits the
water) then pull it tight to take
out the slack...mark it at top of well
opening by pinching
a piece of tape around
the twine...pull the
fishing bobber out...lay
twine/string on
the the ground and
measure. That is your static water level.
|